Skip to content

New website. Enquiries and messages reach us, but no email receipt is sent yet.

Dampers and sliding dampers

Galvanised throttle damper, tight, pneumatic

Tight galvanised throttle damper with pneumatic actuator, Ø 80–500 mm.

Some texts on this page are currently available in Norwegian only.

Pless no.
SP-710031
Range
36 variants
Product area
Galvanised duct systems

Galvanised throttle damper in a tight design with a pneumatic actuator, for automatic opening and closing. The damper is controlled by an electrically operated valve.

Design

  • Nominal diameter 80–500 mm.
  • Wall thickness 1.0 mm.
  • Pneumatic actuator; variants with a 230 V solenoid valve are marked in the table.
  • End type as shown in the table.

How to choose

Choose the nominal diameter in the table, with or without solenoid valve, and send an inquiry.

Variants

Applies to all variants: Wall thickness 1 mm, End type f.lyn, Design tight, with pneumatic actuator

Find the right variant

Choose nominal diameter (mm) · 18 available with your choices

The number under each value is the number of variants.

36 of 36 variants match your choices

36 variants. Type the size above, or show the full list.

Dimension drawing

Dimension drawing of a galvanised throttle damper with pneumatic actuator, ø80–160 mm
Dimension drawing of a galvanised throttle damper with pneumatic actuator, ø80–160 mm
Dimension drawing of a galvanised throttle damper with pneumatic actuator, ø180–500 mm
Dimension drawing of a galvanised throttle damper with pneumatic actuator, ø180–500 mm

Technical data

General

Surface treatment
galvanised