Why the bend matters so much
In a pneumatic line, air moves powder or granulate through the pipe. On the straight sections, the product goes straight ahead. In the bend, it has to change direction. Then it hits the pipe wall. This is where the pipe works hardest.
That is why the bend is often the first place you see wear. A product that wears, wears most where it turns. If the product is fragile, the bend is also where it gets the roughest treatment. So the bend is not a small part you choose at the end. It is a part you should think about early.
There is no single bend that is right for every plant. What suits you depends on what you convey and how the line is laid out. A hard and sharp product makes different demands than a soft one. That is why the bends come in several materials.
We at Pless Industri in Skien supply pipe systems for pneumatic conveying from the German manufacturer HS Umformtechnik. We help you choose material and dimension. We do that in a conversation with you. We ask what you move, where it wears today, and what the line looks like. Then we look together at what you should choose.
It helps if you know a little before you get in touch. Which product runs in the line? What material are the pipes made of today? Where have you replaced parts before? If you do not have the answers, we take it from there. These are the bends you can ask us about:
- Cold-bent pipe bends in stainless steel 1.4301
- Wear-resistant HVA NIRO® bends for abrasive products
- Bends in aluminium AlMgSi 0.5
- Bends in borosilicate glass 3.3
If your product wears hard on the pipe, HVA NIRO® is the first thing you should ask about. If stainless steel works well today, 1.4301 is a natural place to start. Aluminium is lighter than steel. Through glass, you can see what is happening in the line. We cannot say which one is right for you until we know your product and your plant. If you are wondering which bend to choose, you can ask us at Pless. You will find the range on the page for the pipe systems from HS Umformtechnik.
Written by Pless Industri. Photo from production at HS Umformtechnik, used with permission.



